Alliance Designer Products Inc.Alliance DP Gator Dust Bond

Gator Dust Bond : Polymeric Stone Dust

How to Use Polymeric Stone Dust

  1. Install natural stones on crushed stone bedding that is well compacted.
  2. Sweep Gator Dust Bond in between the natural stone joints.
  3. Hit the natural stones with a rubber hammer; this will make Gator Dust settle firmly into the joints by removing air pockets.
  4. Sweep off all excess Gator Dust on the natural stone surface. Ensure that Gator Dust lies 3mm (1/8") below the top of the paver (repeat step 3 if necessary).
  5. Direct a fine mist of water in the air to dampen all the Gator Dust joints. Dampen until there is water retention on joints surface (45 seconds).
  6. Minimize or avoid, if possible, walking on the natural stones for 24 hours after the installation of Gator Dust.

How to Use Polymeric Stone Dust

PLEASE NOTE
Gator Dust Bond hardens like concrete and will crack if the crushed stone base has movement.


NEVER USE POLYMERIC STONE DUST WHEN PAVERS ARE INSTALLED ON A CONCRETE SLAB. GATOR DUST BOND MIGHT LEAVE A WHITE RESIDUE IF USED ON CONCRETE PRODUCTS

Where to buy Gator Dust:

Contact us by phone or email to locate a dealer near you.

Toll-free in Canada & U.S.:
1-866-212-1611

Email:

Alliance Designer Products inc.
Innovator in landscaping products & manufacturer of SuperSandBond
225, Bellerose Bvld W.
Laval, Canada, H7L 6A1
Phone: 450-668-8610